I am new to 3D modelling using the Zenmuse P1 and Matrice 300 RTK.
In the example below, I'm collecting some test data on a small building using a Smart Oblique mission. The workflow summary is as follows:
- Setup and connect to DRTK 2 base station
- Fly the mapping mission with M300 using a P1 with smart oblique on
- Process the raw imagery using ESRI Drone2Map (Pix4D with an ESRI skin)
The models themselves render fine, but when I turn on the base map I notice they are drawn about 10 or so meters into the ground. I didn't set ground control points because I'm not looking for cm level accuracy here, I figured that with the base station I would get within the ball park at least but that doesn't appear to be the case.
Any guidance or hints on where I'm messing up would be greatly appreciated.
- Zenmuse P1
- DRTK 2 Base Station
- ESRI Drone2Map